Heater Rod - Star Micronics WinType 4000 Technical Manual

REPLACEMENT AND ADJUSTMENT OF PARTS

3.3 Heater Rod

[Disassembly]
Warning: Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
Caution 1: Be careful not to get burnt when working on the fuser since it becomes very hot while the printer is being
operated.
(1) Remove the following units:
• Fuser assembly (Refer to section 3.1)
• Screw [1]
• Two screws [2]
• Fuser cover [3]
• Two screws [4]
• Fuser right housing [5]
• Screw [6]
• Two screws [7]
• Fuser left housing [8]
• Pinch roller [9]
[7]
[8]
[2]
[3]
[6]
– 40 –
[1]
[9]
[2]
[5]
[4]