Table of Contents
Advertisement
1.8.4 Non-volatile Code Selection
Non-volatile code 0 is automatically chosen after non-volatile settings mode has been entered.
Each time KEY 1 is pressed, the non-volatile code changes according to the order shown in section 1.8.3 List of
Non-volatile Codes. Use this key to select the appropriate non-volatile code.
"SELECTING" is displayed in the bottom row of the LCD followed by the chosen non-volatile code.
1.8.5 Setting the Data
After the non-volatile code has been chosen, "SELECTING" will change to "WRITING" when KEY 0 is pressed
and the value will increase by one. The data is entered in non-volatile memory at the same time that it is set.
Set the data by pressing the SET.KEY (KEY 0) until the desired value is displayed.
If KEY 0 is pressed when the data is at its maximum value, the data value will return to its minimum, 0.
(Example for Non-volatile Code 2)
N
V
0
?
KEY1 ON
N
V
1
?
KEY1 ON
N
V
2
?
KEY1 ON
N
V
F
?
N
V
2
2
KEY0 ON
N
V
2
3
KEY0 ON
N
V
2
4
KEY0 ON
N
V
2
0
KEY0 ON
N
V
2
1
– 75 –
MAINTENANCE GUIDE
KEY1 ON
KEY0 ON
Advertisement
Chapters
Table of Contents
