Star Micronics WinType 4000 Technical Manual page 45

(2) Remove the following units:
• Two screws [10]
• Paper guide [11]
Caution 2:
• Screw [13]
(3) Pull out the heater rod
Caution 3:
[13]
[Assembly]
Reverse the disassembly procedure.
Caution: When installing PJ114
diodes should be installed with the cathode marks in the correct position.)
REPLACEMENT AND ADJUSTMENT OF PARTS
Do not to lose the spring [12] that is placed over the screws.
[14] from the heat roller
Do not touch the glass surface of the heater rod
it.
[10]
[12]
[17] , be sure the green ground wire
[15] .
[14]
[15]
[16] and the diodes are installed correctly. (The
– 41 –
Be sure that the power is disconnected!
since oil from your hands may damage
[10]
[12]
[11]
[14]
[16]
[17]