Bottom Cover - Star Micronics WinType 4000 Technical Manual

REPLACEMENT AND ADJUSTMENT OF PARTS

1.4 Bottom Cover

[Disassembly]
Warning: Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
(1) Remove the front cover. (Refer to section 1.1)
Caution: Be careful not to break the front cover interlock actuator when installing the bottom cover while the front
cover is removed.
(2) Turn the printer over onto its top cover. (Turn it upside down.)
(3) Remove the four screws [1] securing the bottom cover and remove the bottom cover [2].
(4) Disconnect CN121 [3] from the laser diode [4] and remove the harness [5] from the bottom cover.
(5) Disconnect PJ152 [6] from the HVPS and remove the bottom cover.
[Assembly]
Reverse the disassembly procedure.
Pass the harness [5] through the bottom cover [2], then connect it to connector CN 121. Do not connect the
Caution 1:
harness directly to connector CN 121 [3] without passing it through the bottom cover.
Caution 2: Insert PJ152 from the fan into the HVPS before installing the bottom cover.
[1]
[6]
– 28 –
[4]
[2]
[5]
[3]