Main Motor - Star Micronics WinType 4000 Technical Manual

2.8 Main Motor

[Disassembly]
Warning: Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
(1) Remove the following units:
• Top cover assembly (Refer to section 1.2)
• Feeder assembly (Refer to section 2.1)
• Fuser assembly (Refer to section 3.1)
• Drive assembly (Refer to section 2.7)
• Two screws [1]
• Main motor [2]
[Assembly]
Reverse the disassembly procedure.
Since the holes [3] attaching the main motor [2] to the drive assembly determine the position in which it is
Note:
installed, it is not necessary to adjust the backlash.
Caution: Install the main motor with the harness [4] facing towards the rear.
[1]
REPLACEMENT AND ADJUSTMENT OF PARTS
[3]
– 37 –
Be sure that the power is disconnected!
[2]
[4]