Rear Cover - Star Micronics WinType 4000 Technical Manual

1.3 Rear Cover

[Disassembly]
Warning: Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
(1) Disconnect the printer's power cord from the wall outlet.
(2) Remove the two screws [1] securing the MCU PWB interface connector (PJ31) to the rear cover.
(3) Remove the two screws [2] on the top left and right that are attaching the rear cover to the printer.
(4) Remove the center screw and the two screws [3] on the bottom left and right and remove the rear cover
[4].
[2]
[Assembly]
Reverse the disassembly procedure.
REPLACEMENT AND ADJUSTMENT OF PARTS
[3]
[1]
– 27 –
Be sure that the power is disconnected!
[4]