Star Micronics WinType 4000 Technical Manual page 83

Code
1. The exit sensor was left on and was not turned
off between the time the pre-regi. sensor was
turned on and the end of the regulation time.
2. The exit sensor was turned on while the power
E4 switch was ON.
3. The exit sensor was turned on while the interlock
switch was ON.
4. The exit sensor was turned on during warm up or
during the ERASE cycle.
(Refer to section 3.5 Paper Feed Regulation Time.)
The exit sensor was not turned on between the time
that the pre-regi. sensor was turned on and the end of
E3 the regulation time.
(Refer to section 3.5 Paper Feed Regulation Time.)
1. The pre-regi. sensor was turned on between the
time that the paper was fed into the printer until
and the end of the regulation time. (Very fast
paper jam)
2. The pre-regi. sensor was not turned on from the
time that the paper was fed into the printer until
after the regulation time had passed. (Misfeed
E2 jam)
3. The pre-regi. sensor was turned on while the
power switch was ON.
4. The pre-regi. sensor was turned on while the
interlock switch was ON.
5. The pre-regi. sensor was turned on during warm
up or during the ERASE cycle.
(Refer to section 3.5 Paper Feed Regulation Time.)
*1: If a paper jam occurs within 3.2 seconds after the solenoid begins operating, all other parts will immediately
stop running and the main motor will stop running after 3.2 seconds.
Cause
– 79 –
MAINTENANCE GUIDE
Operation
Clearing the Display
The main motor, the ROS controller and the
fuser controller will immediately stop run-
ning. *1
However, when the size of the paper fed
into the printer is larger than a paper size
that can be identified by the printer, the
main motor will be stopped after the paper
is fed through the printer.
After opening the front cover assembly and
removing the paper, close the front cover
assembly.
The main motor, ROS controller and fuser
controller will immediately stop running. *1
After opening the front cover assembly and
removing the paper, close the front cover
assembly.
The main motor, ROS controller and the fuser
controller will immediately stop running. *1
After opening the front cover assembly and
removing the paper, close the front cover
assembly.