Fuser; Fuser Assembly - Star Micronics WinType 4000 Technical Manual

REPLACEMENT AND ADJUSTMENT OF PARTS
3.

FUSER

3.1 Fuser Assembly

[Disassembly]
Warning: Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
Caution: Be very careful not to get burnt when working on the fuser since it becomes hot while the printer is being
operated.
(1) Remove the following units:
• Top cover (Refer to section 1.2)
• PJ114
• PJ131
• PJ132
• Screws
• Fuser assembly
Remove the two screws
remove it from the frame.
[5]
[3]
[Assembly]
Reverse the disassembly procedure.
Caution: When installing the fuser assembly
parts.
[1]
[2]
[3]
[4]
[5]
[4] securing the fuser and while lifting the rear of the fuser assembly
[2]
[5] on the printer, be sure the harnesses are not pinched between any other
[4]
– 38 –
[5] ,
[1]