Lvps Assembly - Star Micronics WinType 4000 Technical Manual

5.3 LVPS Assembly

[Disassembly]
Warning: Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
(1) Remove the following units:
• Rear cover (Refer to section 1.3)
• PWB chassis (Refer to section 5.1)
(2) Disconnect PJ11 [1].
To disconnect PJ11, press down on the white, plastic sliding lock [2] to unlock it and pull out the harness.
(3) Remove the three screws [4] securing the LVPS assembly [3] to the PWB chassis and remove the LVPS
assembly.
Caution: There are four screws securing the LVPS to the LVPS frame, but it is not necessary to remove these screws
in order to remove the LVPS assembly.
[Assembly]
Reverse the disassembly procedure.
REPLACEMENT AND ADJUSTMENT OF PARTS
– 57 –
Be sure that the power is disconnected!