Hvps - Star Micronics WinType 4000 Technical Manual

REPLACEMENT AND ADJUSTMENT OF PARTS

4.6 HVPS

[Disassembly]
Warning: Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
(1) Remove the following units:
• Front cover (Refer to section 1.1)
• Bottom cover (Refer to section 1.4)
(2) Turn the printer onto its front. (Turn it sideways so that the front of the printer is pointing downwards.)
(3) Disconnect PJ151 [1] from the HVPS [2].
(4) Inserting a miniature standard screwdriver [3] into the small hinge hole [4] on the front cover, unhook
the latch supporting the HVPS and remove the HVPS [2].
Caution: If, while the HVPS is being removed, it catches on the drive assembly, carefully remove it without damaging
the contacts.
Note: The HVPS is supported by the latch mentioned above in (4) and the slot on the bottom cover.
[4]
[3]
[Assembly]
Reverse the disassembly procedure.
Caution: If, while the HVPS is being installed, it catches on the drive assembly, use a ruler or any other flat object
to guide in the HVPS without damaging any contacts.
– 52 –
[2]
[1]