Table of Contents
Advertisement
Set Up Telnet Connection
A Telnet connection allows you to access VTrak's CLU over the network. This
allows RAID management over a greater distance from the VTrak itself.
This procedure is required for a Host PC that does not have an available RS-232
serial port.
The CLU screen looks and works exactly the same over a Telnet connection as it
does over a serial connection.
Enable Telnet on VTrak
VTrak's Telnet service is disabled by default. Follow these instructions to enable
Telnet.
1.
Connect the RS-232 cable between the Host PC and VTrak.
Refer to Step 7 on page 20 for the RS-232 settings and setup.
2.
Launch HyperTerminal or Minicom.
3.
In the CLU Main Menu, select Network Management > Telnet and choose
Enable/disable Telnet.
This action enables the Telnet support.
Make a Telnet Connection
To start the telnet program,
1.
Go to the command line prompt (Windows) or click the terminal icon (Linux),
then run:
telnet 192.168.1.56 2300
The IP address above is only an example. Use your VTrak's Management
port IP address. 2300 is the Telnet port for the VTrak.
The telnet login screen appears:
Telnet Login
Please enter your user name>administrator
Please enter the password for user administrator>*******
2.
Type the user name and password.
The default user name is administrator. The default password is password.
The CLU Main Menu appears.
Main Menu
1. Subsystem Management
2. Physical Drive Management
3. Logical Drive Management
23
Chapter 2: Installation
Advertisement
Table of Contents
