Table of Contents
Advertisement
--------------------------------------------------------------------------
Management Port IP Address: 10.0.0.2
Subnet Mask: 255.0.0.0
Gateway IP Address: 0.0.0.0
-------------------------------------------------------------------------
Management Port
1. Management Port IP
2. Subnet Mask
3. Gateway
R. Return to Previous Menu
Please enter your menu choice>1
2.
Press 1 and Enter to select Management Port IP.
--------Configure Management Port IP address--------
Current management port IP Address: 10.0.0.2
Modify management port IP address(y/n)?>y
New management port IP address>192.168.1.56 (an example only)
New management port IP address: 192.168.1.56
Press Enter key to return
3.
Press Y and Enter to modify the management port IP address.
4.
Type the new IP address and press Enter.
VTrak confirms the new address.
5.
Press Enter to return to the Network Management menu.
6.
Repeat steps 1 through 5 to set the Subnet Mask and Gateway IP address
7.
Reboot the VTrak for these changes to take effect.
Telnet
Telnet allows you to use the CLU to manage VTrak over a network. The Telnet
screen looks the same as the CLU screen, except that you have to log in. You
must enable Telnet on VTrak before you can establish a Telnet connection.
Enable/Disable Telnet
1.
Press 2 and Enter to access the Telnet settings.
Current Telnet settings:
Telnet:
Timeout:
Port:
User Name: administrator
---------------------------------------------------
enabled
600 seconds
2300
159
Chapter 5: Management with the CLU
Advertisement
Table of Contents
