Chapter 4: Management With Webpam Pro; Vtrak Status Indicators - Promise Technology VTRAK 15200 User Manual

Chapter 4: Management with WebPAM PRO

• VTrak Status Indicators (below)
• Drive Status Indicators (page 62)
• Audible Alarm (page 63)
• Log-In /Log-0ut (page 64)
• Subsystem Management (page 67) •
• User Management (page 72)
This chapter describes using WebPAM to monitor and manage your RAID
system. This chapter is divided into sections for major WebPAM components as
shown above.

VTrak Status Indicators

Even though WebPAM PRO offers comprehensive monitoring of VTrak, the LED
indicators on the VTrak unit provide important status information.
When the power is switched on, the LEDs on the front of the VTrak will light up.
FRU
Power
Status
Figure 1. VTrak 15200 Front Panel LEDs
When boot-up is finished, the Power, FRU and Logical Drive LEDs will display
green. When the VTrak is functioning normally, the Controller Heartbeat LED
blinks five times in five seconds, ten seconds dark, blinks five times again. The
iSCSI LEDs flash green when there is activity on that channel. See the table
below.
•
•
•
•
•
Logical Drive
Status
61
Utility Configuration (page 82)
Security (page 84)
Controller Management (page 85)
Physical Drive Management (page 100)
Logical Drive Management (page 103)
Enclosure Management (page 121)
iSCSI-1 iSCSI-2
Activity Activity
Controller
Heartbeat