Program 90 - Initialize Programs 00~*99 - Toshiba Strata DK14 Programming Manual

Initialization & Test
Program 90 – Initialize Programs 00~*99
Program 90 – Initialize Programs 00~*99
Processor Type:
Program Type:
Initialized Default:
ÃÆ ÃÆ Ã! Ã" 
Enter programming
mode
Program 90 Overview
Program 90 enables you to clear all customer data and initialize individual programs or range of
programs.
Important!
Notes
Running Program 91-9, automatically runs Program 90.
To initialize all programs without dropping calls or erasing user names, speed dial numbers,
voice mail ID codes, etc., enter
Each "*" program record sheet immediately follows the program record sheet having the same
number (example: *31 follows 31 record sheet). However, in system memory all "*" programs
follow Program 99. Therefore, " " program ranges must be initialized separately from non-
star programs unless initializing all system Programs (00**99).
For example, to initialize Programs 30, *30, 31, *31, and 32: initialize the range (30*32), for
Programs 30, 31, 32; and the range (*30**31), for Programs *30 and *31.
If you are installing the system for the first time, run Program 91-9 to erase random data from
RAM (caused by battery jumper movement to the internal battery). You can then skip Program
90, since Program 91-9 automatically runs Program 90.
2-4
DK14, DK40i, All RCTUs
Initialization
See individual programs
Tƒx… (  C‚yq  Tƒx…
Programs to be initialized. Add
a range of program numbers
by entering XX*XX or XX**XX.
Press LED Buttons 01 and 02
LEDs 01 and 02 must be ON
When installing the system, you must run Program 91-9 which runs Program 90
(before running any other program); if you do not, the system could begin to operate
erratically.

Æ  ! C‚yq  Tƒx… Æ Æ C‚yq
End Program 90
LEDs 01 and 02 must flash
as "Programs to be initialized."
 Tƒx… Æ Æ C‚yq
Exit programming mode
Strata DK Programming 5/99