Program *66-6 - Ldn/Trunk Group To Channel Group Assignments - Toshiba DK14 Programming Manual

ISDN
Program *66-6 – LDN/Trunk Group to Channel Group Assignments
Program *66-6 – LDN/Trunk Group to Channel Group
Assignments
Processor Type:
Program Type:
Initialized Default:
✱ ✱ ✱ ✱
Channel
Index
Group
Program *66-6 Overview
This program assigns Listed Directory Numbers (LDNs) trunk groups to the member's channel
group.
Note
For Programs *66-5 and *66-6:
Multiple calls can be received with the same LDN. The LDN and Channel Group information in
*66-5 and *66-6 must match. Calls are assigned the next available non-busy port as follows:
o For PRI: Choose the highest available port to the lowest.
o For BRI: Choose the lowest available the highest.
o Multiple LDNs can be assigned to the same CO appearances.
Note
7-34
DK40i, all RCTUs (Release 4.0 or higher) and BCUs
Trunk, PRI and BRI
Blank
✱
SEL = 6
Enter the Channel Group Number:
0 = BRI; 1~8 = PRI
Enter the LDN Index (1~48)
Channel
CO Line Ports
Group
The number of direct appearing CO lines cannot exceed the number of CO ports allocated
in Program 03. One PRI card, Type 79, assigns 24 B-channels; thus allowing 24 direct
appearances.
In Release 4.15, DID/DNIS digits must be registered in this program in order to route
incoming calls on PRI.
GRP = Select ISDN trunk ports for each LDN index.
Press
Index
CO Line Ports
or for the next CO line ports.
Channel
Index
CO Line Ports
Group
Strata DK Programming 5/00