Upgrade the firmware on the G700 Media Gateway
Verifying the contents of the tftpboot directory
●
Determining which firmware to install on the G700
●
Installing new firmware on the P330 Stack Processor
●
Installing new firmware on the G700 Media Gateway Processor
●
Installing new firmware on the media modules
●
Setting rapid spanning tree on the network
●
Installing new firmware on other G700 media gateways
●
Post-upgrade tasks
Stopping IA770 INTUITY AUDIX Messaging, if installed
●
Installing IA770 service pack (or RFU) files, if any
●
Starting IA770 INTUITY AUDIX Messaging, if installed
●
Verifying start up of IA770 INTUITY AUDIX Messaging, if installed
●
Saving translations
●
If using IA770, administering switch integration for H.323
●
Administering IA770 (Release 1.3 or earlier)
●
Testing to verify system functionality
●
To check media modules
●
To enable scheduled maintenance
●
To busy out trunks
●
To check for translation corruption
●
To resolve alarms
●
To re-enable alarm origination
●
To back up the system
●
To restart LSPs (if any)
●
Before going to the customer site
The procedures in this section should be completed before going to the customer site or before
starting a remote installation.
on page 616
on page 616
on page 617
on page 617
on page 617
on page 617
on page 617
on page 618
on page 618
on page 618
Before going to the customer site
on page 604
on page 605
on page 606
on page 607
on page 609
on page 611
on page 612
on page 613
on page 614
on page 614
on page 616
on page 616
on page 615
Issue 10.2 May 2007
543