Identifying The Survivable Processor On The Primary Controller - Avaya G700 Installing And Upgrading

Hide thumbs Also See for G700:

Table of Contents

IP Interfaces Screen

change ip-interfaces procr

Enable Ethernet Port? y

Nework Region: 1

2. The field Enable Ethernet Port? should indicate y (yes). The Node Name should be the IP

address of the S8300 media server.

3. In the Allow H.323 Endpoints field, enter a 'y' to allow H.323 endpoint connectivity to the

4. In the Allow H.248 Endpoints field, enter a 'y' to allow H.248 media gateway connectivity

to the server.

5. In the Gatekeeper Priority field, enter a value is used on the alternate gatekeeper list. The

lower the number the higher the priority. Valid values for this field are one through nine with

five being the default. This field displays only if the allow H.323 endpoints field is set to y.

Identifying the Survivable Processor on the primary controller

If the primary server has LSPs, you must enter the LSP node names on the LSP form to enable

the LSPs to get translations updates from the primary controller. Once the LSPs are

successfully entered on the LSP form, their status can be viewed with the list

survivable-processor command.

The LSP node names must be administered on the node-names-ip form before

they can be entered on the LSP form.

1. At the SAT command line, type add survivable-processor <name>, where <name>

is the LSP name from the Node Names screen.

The Survivable Processor screen appears.

Node Name: procr

IP Address: 135.9.41.146

Subnet Mask: 255.255.255.0

Administer Communication Manager

IP INTERFACES

Allow H.323 Endpoints? y

Allow H.248 Gateways? y

Gatekeeper Priority: 5

Issue 10.2 May 2007