Associating Lsps With Network Regions - Avaya G700 Installing And Upgrading

Installing a new G700 with an S8300 using the Avaya Installation Wizard
1. At the SAT prompt, type change ip-network-region 1.
The S8300 displays the IP Network Region screen.
IP Network Region Screen
change ip-network-region 1
Region: 1
Location:
Name:
MEDIA PARAMETERS
Codec Set: 1
UDP Port Min: 2048
UDP Port Max: 3048
DiffServ/TOS PARAMETERS
Call Control PHB Value: 34
802.1P/Q PARAMETERS
Call Control 802.1p Priority: 7
H.323 IP ENDPOINTS
H.323 Link Bounce Recovery? y
Idle Traffic Interval (sec): 20
Keep-Alive Interval (sec): 5
2. If necessary, complete the fields as described in Administration for Network Connectivity for
Avaya Communication Manager, 555-233-504.
Note:
It is strongly recommended to use the defaults in the screen. However, for the
Note:
RTCP Enabled and RSVP Enabled fields, the entry should be n (no).
3. Press F3 (Enter) to submit the screen.

Associating LSPs with Network Regions

If the primary controller has LSPs, you can associate each LSP with one or more network
regions. In the event of a network failure, IP telephones assigned to a network region will
register with an LSP associated with that region.
This procedure associates up to six LSPs with a network region.
176 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Authoritative Domain:
Audio PHB Value: 46
Video PHB Value: 26
Audio 802.1p Priority: 6
Video 802.1p Priority: 5
Keep-Alive Count: 5
IP NETWORK REGION
Intra-region IP-IP Direct Audio: yes
Inter-region IP-IP Direct Audio: yes
IP Audio Hairpinning? y
RTCP Reporting Enabled? n
RTCP MONITOR SERVER PARAMETERS
Use Default Server Parameters? y
AUDIO RESOURCE RESERVATION PARAMETERS
Page 1 of 19
RSVP Enabled? n