Avaya G700 Installing And Upgrading page 516

Hide thumbs Also See for G700:

Table of Contents

Manual installation of a new G700 without an S8300

To install media module firmware

1. Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on

the G700 motherboard).

This VoIP module does not occupy a physical position like other media modules.

2. At the P330-1(configure)# prompt, type session mgp.

3. At the MG-001-1(super)# prompt, type configure to change to the configuration mode.

4. Type copy tftp mm-image v<slot #> <filename mm>

<tftp_server_ip_address>

<slot #> is the slot of the specific media module,

<filename mm> the full-path name of the media module firmware file in a format such as

mm712v58.fdl, and

<tftp_server_ip_address> is the ip address of the S8300.

Two or three minutes will be required for most upgrades. The VoIP media module upgrade

takes approximately 5 minutes. Screen messages indicate when the transfer is complete.

5. After you have upgraded all the media modules, verify that the new versions are present.

At the MG-???-1(configure)# prompt, type show mg list_config

The list of software appears.

Show MG list_config

------ -----

6. In the TYPE column, find the particular media module (v1 through v4), then check the

matching field in the FW VINTAGE column to see if it matches the planning documentation.

Slot V1 can contain either a media module or the S8300, which will show as

7. Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP

firmware identified in the planning documentation.

516 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server