Accessing The S8300 - Avaya G700 Installing And Upgrading

Installing a new G700 with an S8300 using the Avaya Installation Wizard
Software and firmware update reminder
When the installation is complete, the system reboots automatically and the telnet connection is
lost. The reboot takes 1–3 minutes without the IA770 application and 3-6 minutes if the IA770 is
present.
6. Click Start > Run to open the Run dialog box on your laptop.
7. Type ping -t 192.11.13.6 and press Enter.
Wait for the reply.

Accessing the S8300

To perform the installation and upgrade procedures you will need to connect your laptop to the
S8300 Services port using a crossover cable. For a direct connection to the S8300 Services
port, your laptop must be properly configured. See
the services port
You will use SSH and the Maintenance Web Interface to perform the procedures. See the
following:
Accessing the server's command line interface with SSH
●
Logging in to the S8300 Web Interface from your laptop
●
Note:
Communication Manager has telnet turned off by default. Therefore, telnet is not
Note:
available after remastering of the hard drive is complete during an initial server
installation. However, if the customer later chooses to enable telnet, you may be
able to use telnet to access the server's command line interface.
See About connection and login methods
and log into the G700.
128 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 42.
Laptop configuration for direct connection to
on page 55
on page 57
on page 41 for details on how physically to connect