Avaya G700 Installing And Upgrading page 457

To determine if new firmware for the P330 stack processor is necessary
1. At either the P330-1(super)# or P330-1(configure)# prompt, type dir.
The system displays the directory list of software for the P330 stack processor.
Directory list for P300 stack processor
M# file
-- ----
1 module-config
Configuration
1 stack-config
1 EW_Archive
1 Booter_Image
2. Check the version number (ver num) of the EW_Archive file to see if it matches the Release
Letter.
If not, you must upgrade the P330 stack processor.
3. Type show image version
The system displays the list of software.
Show image version List for P330 stack processor
Mod Module-Type
------ -----------
3 Avaya G700 media gateway
3 Avaya G700 media gateway
4. Check the version number of the stack software image file in Band B to see if it matches the
your planning document.
If not, you must upgrade the P330 stack processor.
To determine if new firmware is required for the MGP, VoIP module, and installed
media modules
1. Type session mgp
2. At the MG-001-1(super)# prompt, type show mg list_config
The system displays the list of software.
ver num file type
------- ----------
N/A Running Conf
N/A Running Conf
4.0.4 SW Web Image
3.2.5 SW BootImage
Install New Firmware on the G700
file location file description
------------- ----------------
Ram Module
Ram Stack Configuration
NV-Ram WEB Download
NV-Ram Booter Image
Issue 10.2 May 2007
Bank Version
---- -------
A 0.0.0
B 4.0.17
457