Avaya G700 Installing And Upgrading page 746

Hide thumbs Also See for G700:

Table of Contents

Manual upgrade of an existing S8300B and G700 to S8300C with R4.0

2. Verify the response,

Command Successfully Completed

3. Repeat for each media module to be upgraded.

To install media module firmware

1. Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on

the G700 motherboard).

This VoIP module does not occupy a physical position like other media modules.

2. At the P330-1(configure)# prompt, type session mgp.

3. At the MG-001-1(super)# prompt, type configure to change to the configuration mode.

4. Type copy tftp mm-image v<slot #> <filename mm>

<tftp_server_ip_address>

<slot #> is the slot of the specific media module,

<filename mm> the full-path name of the media module firmware file in a format such as

mm712v58.fdl, and

<tftp_server_ip_address> is the ip address of the S8300.

Two or three minutes will be required for most upgrades. The VoIP media module upgrade

takes approximately 5 minutes. Screen messages indicate when the transfer is complete.

5. After you have upgraded all the media modules, verify that the new versions are present.

At the MG-???-1(configure)# prompt, type show mg list_config

The list of software appears.

Show MG list_config

------ -----

6. In the TYPE column, find the particular media module (v1 through v4), then check the

matching field in the FW VINTAGE column to see if it matches the planning documentation.

746 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server