Installing New Firmware On The Media Modules - Avaya G700 Installing And Upgrading

Manual upgrade of an existing G700 without an S8300 to R4.0
Example: Show mg list_config
SLOT TYPE
---- ------ -----
V0 G700
V1 ICC
V2 DCP
V3 ANA
V4 DS1

Installing new firmware on the media modules

For upgrades of active media modules, you need to take the media modules out of service
before initiating the upgrade process. To do this, go to a SAT session on the primary controller
and issue a busyout command.
Note:
Skip this busyout procedure if the media modules are not in service; for example
Note:
during an initial installation.
To busyout board (for active media modules)
1. Go to a SAT session on the primary controller and enter the command,
busyout board vx
where x is the slot number of the media module to be upgraded.
2. Verify the response,
Command Successfully Completed
3. Repeat for each media module to be upgraded.
To install media module firmware
1. Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on
the G700 motherboard).
This VoIP module does not occupy a physical position like other media modules.
2. At the P330-1(configure)# prompt, type session mgp.
3. At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
768 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
CODE SUFFIX HW VINTAGE
------ ----------
DAF1 A 00
S8300 A 72
MM712 A 2
MM711 A 2
MM710 A 1
FW VINTAGE VOIP FW
---------- -------
230(A) 67
00 N/A
58 N/A
57 N/A
58 N/A