Avaya G700 Installing And Upgrading page 477

Table 30: IP interfaces field descriptions (continued)
Field
Enable Ethernet
Port?
Network Region
VLAN
Target socket
load
Receive Buffer
TCP Window
Size
Link
Allow H.323
Endpoints
Allow H.248
Gateways?
Gatekeeper
Priority
Auto?
Speed
Duplex
3. Close the screen.
Conditions/Comments
The Ethernet port must be enabled (y) before it can be
used. The port must be disabled (n) before changes can
be made to its attributes on this screen.
The region number for this IP interface.
The VLAN number assigned to the C-LAN, if any.
The threshold for the number of sockets used by this
C-LAN within the same Gatekeeper Priority as that of
other IP interfaces. If the targeted number is exceeded
on a CLAN, a warning alarm is generated. If the targeted
percentage is exceeded on an PE interface, a procr error
is generated.
The threshold for the number of sockets used by this
C-LAN that triggers a warning message to be sent to the
error log.
This display only field shows the unique number for the
Ethernet link. The Ethernet link was assigned on the data
module form.
Enter a 'y' to allow H.323 endpoint connectivity on this
CLAN. Enter 'n' if you do not want H.323 endpoints to
connect to this CLAN.
Enter 'y' to allow H.248 gateway connectivity to this
CLAN. Enter 'n' if you do not want H.248 gateways to
connect to this CLAN.
This value is used on the alternate gatekeeper list. The
lower the number the higher the priority. Valid values for
this field are one through nine with five being the default.
This field displays only if the allow H.323 endpoints field
is set to a yes on this form.
Enter 'y' or 'n' to set auto-negotiation.
Enter 10 or 100 Mbps if Auto was set to no.
Enter half or full if Auto was set to no.
Administer Communication Manager
2 of 2
Issue 10.2 May 2007 477