Avaya G700 Installing And Upgrading page 639

To check for translation corruption
●
To save translations
●
To disable alarm origination
●
Note:
It is no longer necessary to disable Terminal Translation Initialization (TTI) before
Note:
an upgrade or to enable it after an upgrade.
To display IA770 alarms, if IA770 is enabled
1. On the Maintenance Web Interface, click Messaging Administration.
2. On the Messaging Administration menu, under Logs, click Alarm.
3. On the Alarm Log screen, type today's date. Leave the defaults in all other fields.
4. Click Display.
5. Resolve any alarms that are listed.
To clear alarms
1. On the Maintenance Web Interface under Alarms, click Current Alarms.
2. If no alarms are listed, skip the next two steps.
3. If alarms are listed, click Clear All.
4. Resolve any remaining major alarms through the Communication Manager SAT.
To check link status
1. Open a SAT session.
2. Enter display communication-interface links.
Note all administered links.
3. Enter status link number for each administered link.
4. Enter list signaling group.
Note the signaling groups listed by number.
5. For each of the signaling groups listed, enter status signaling group number.
Make a note (write down) of any links that are down.
To record all busyouts
1. At the SAT prompt, type display errors and press Enter.
2. Look for type 18 errors and record (write down) any trunks that are busied out — you will
return them to their busy-out state after the upgrade.
On-site Preparation for the Upgrade
Issue 10.2 May 2007 639