Avaya G700 Installing And Upgrading page 328

Telephones and adjunct systems
Figure 27: Connecting an IP telephone with an external splitter
Connection to
Power over LAN Hub
Before connecting telephones or other end devices to the 1152A1 PDU, determine if the device:
Is Power over LAN Enabled or not.
●
If not, you may safely connect the telephone; however, the port supplies no power and
functions as a normal Ethernet data port.
Requires an external splitter or whether it requires only a single RJ45 connection.
●
If an external splitter is needed, be certain to use a splitter with the correct connector and
polarity.
Power requirements are consistent with the 1152A1 PDU voltage and power ratings.
●
Refer to Appendix B in the user's guide that comes with the unit for voltage and power
ratings.
To connect telephones and other end devices to the 1152A1 PDU
1. Connect an Ethernet cable to the telephone using an external splitter or directly (if the
device is Power over LAN Enabled).
2. Connect the opposite end of the same cable to the RJ45 wall outlet.
3. On the front panel of the 1152A1 PDU, monitor the response of the corresponding port LED.
If it lights up GREEN, the unit has identified your telephone as a Power over LAN telephone.
328 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
RJ-45
Female Socket
Power
RJ-45
Male Connector
Data
DC Power
Connector
IP
Phone