Creating A Super-User Login, If Necessary, For R4.0 Or Higher - Avaya G700 Installing And Upgrading

Creating a super-user login, if necessary, for R4.0 or higher

If a super-user login does not exist, you must add at least one before you complete the upgrade.
The easiest way to add a login is with the Maintenance Web pages. Use the following steps only
if you are starting from Release 4.0 software or later:
Note:
A craft level login can create a super-user login in Release 4.0 or later.
Note:
Note:
If you are installing software for an S8300 LSP, create the super-user login on the
Note:
primary controller. Then, at the LInux command line on the primary controller, run
the filesync -a <IP_address_of_LSP> command.
To create a login:
1. Ask a customer representative for a login name and password that the customer would like
for the superuser login. If you are a business partner, you can also repeat this procedure to
add the dadmin login.
Note:
Make sure the customer can change this login, its password, or its permissions
Note:
later.
Install the S8300
Issue 10.2 May 2007 129