Avaya G700 Installing And Upgrading page 238

Installing a new G700 without an S8300 using the Gateway Installation Wizard
Add media gateway Screen
add media-gateway 1
Serial No: 012X06230551
Encrypt Link? y
Network Region: 1
Location: 1
Recovery Rule: none
Slot
V1:
V2:
V3:
V4:
V9:
2. Complete the Name field with the hostname assigned to the G700 media gateway.
3. Complete the Identifier field with the serial number of the G700 media gateway.
You can obtain the serial number by typing the show system command at the MGP
command line interface.
!
CAUTION:
Be sure the serial number for the G700 media gateway you enter in this
CAUTION:
procedure matches exactly the serial number displayed in the show system
command. The serial number is case-sensitive, and if entered incorrectly, will
prevent the S8300 media server from communicating with the G700 media
gateway.
4. Complete the Network Region field with the value supplied in the planning documentation.
5. If specifically requested by the customer or your planning documents, type
gateway-announcements in the V9 field.
This field allows you to enable announcements on the G700 media gateway. V9 is a virtual
slot. There is no announcement board associated with it. The announcements for the G700
are available in the G700 firmware and are administered in the same way as
announcements on the TN2301 circuit pack used on S8400, S8500, or S8700-series port
networks.
If there are multiple G700 media gateways sharing announcements, then enable
announcements on the G700 whose trunks will receive the announcements most often.
238 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
MEDIA GATEWAY
Number: 1
Type: g700
Name: Swainsons
Module Type
Registered:
FW Version/HW Vintage:
IP Address:
Controller IP Address:
MAC Address: 00:04:0d:02:06:ca
CF: 8 MB
Site Data:
Name
Page 1 of 1