Completing Pre-Upgrade Tasks - If The Target S8300 Is The Primary Controller - Avaya G700 Installing And Upgrading

Completing pre-upgrade tasks — If the target S8300 is the primary
controller
If the S8300 is configured as an LSP, skip to
controller, LSPs, and G700 media gateways
!
CAUTION:
If you are upgrading an S8300 primary controller that has LSPs registered to it,
CAUTION:
the LSPs must be upgraded before the primary controller. (You can use the SAT
command, list media-gateway, to see if there are LSPs registered to the
S8300.)
Perform the following procedures if you are upgrading an S8300 that is configured as a primary
controller:
To clear alarms
●
To check link status
●
To record all busyouts
●
To disable scheduled maintenance
●
To check for translation corruption
●
To save translations
●
To disable alarm origination
●
Note:
It is no longer necessary to disable Terminal Translation Initialization (TTI) before
Note:
an upgrade or to enable it after an upgrade.
On-site Preparation for the Upgrade
Run the Upgrade Tool to upgrade the primary
on page 281.
Issue 10.2 May 2007 261