Determining Which Firmware To Install On The G700 - Avaya G700 Installing And Upgrading

Determining which firmware to install on the G700

Conduct the following procedure to compare software versions running on the G700 processors
and media modules with the versions in you planning documents. If the versions do not match,
you need to install the new firmware for those components.
To determine if new firmware for the P330 stack processor is necessary
1. At either the P330-1(super)# or P330-1(configure)# prompt, type dir.
The system displays the directory list of software for the P330 stack processor.
Directory list for P300 stack processor
M# file
-- ----
1 module-config
1 stack-config
1 EW_Archive
1 Booter_Image
2. Check the version number (ver num) of the EW_Archive file to see if it matches the Release
Letter.
If not, you must upgrade the P330 stack processor.
3. Type show image version
The system displays the list of software.
Show image version List for P330 stack processor
Mod
------
3
3
4. Check the version number of the stack software image file in Band B to see if it matches the
your planning document.
If not, you must upgrade the P330 stack processor.
To determine if new firmware is required for the MGP, VoIP module, and installed
media modules
1. Type session mgp
2. At the MG-001-1(super)# prompt, type show mg list_config
The system displays the list of software.
ver num
-------
N/A
N/A
4.0.4
3.2.5
Module-Type
-----------
Avaya G700 media gateway
Avaya G700 media gateway
Upgrade the firmware on the G700 Media Gateway
file type file location
---------- -------------
Running Conf Ram
Running Conf Ram
SW Web Image NV-Ram
SW BootImage NV-Ram
file description
----------------
Module Configuration
Stack Configuration
WEB Download
Booter Image
Bank Version
---- -------
A 0.0.0
B 4.0.17
Issue 10.2 May 2007 605