Installing Communication Manager Software; Setting Telnet Parameters - Avaya G700 Installing And Upgrading

Manual installation of a new G700 with an S8300
Push both circuit packs (together) back into the guides, gently and firmly, until the front of
●
each circuit pack aligns with the front of the G700.
For the S8300C circuit pack only, push the module back into the slot V1 guide until the front
of the S8300 module aligns with the front faceplate of the G700.
4. Secure the S8300 faceplate with the thumb screws.
Tighten the thumb screws with a screw driver.
Note:
Unplug any external Compact Flash drive that might be connected to the S8300
Note:
USB ports. The S8300 tries to read any media connected to a USB port. The
S8300 should only read the media on the CD-RW/DVD drive.
5. Power up the G700 by plugging in the power cord.
6. Connect the laptop to the Services port on the faceplate of the S8300.

Installing Communication Manager Software

Note:
You cannot use the SSH protocol to access the hard drive on an S8300 Media
Note:
Server that has never been installed.

Setting telnet parameters

The Microsoft telnet application may be set to send a carriage return (CR) and line feed (LF)
each time you press Enter. The installation program interprets this as two key presses. You
need to correct this before you telnet to the server.
Note:
This procedure is done entirely on your laptop, not on the S8300.
Note:
To set telnet parameters
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type unset crlf and press Enter.
4. Type display and press Enter to confirm that Sending only CR is set.
5. Close the window by clicking on the X in the upper-right corner.
This resets your Microsoft telnet defaults and does not need to be done each time you use
Telnet.
416 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server