Avaya G700 Installing And Upgrading page 453

Table 29 describes the possible optional controllers for an S8300 and S8700/S8710/S8720
primary controller:
Table 29: Possible optional controllers for various primary controllers
If primary Then, controller IP addresses can be
controller is
S8300 First: IP address of the S8300 primary controller.
Next three: one, two, or three IP addresses of S8300s configured as LSPs.
S8400, S8500 First: IP address of the C-LAN for the S8400, S8500, or S8700/S8710/
or S8700, S8720 primary controller or IP address of processor Ethernet-enabled port
S8710, or on S8400 or S8500.
S8720
Next three: one, two, or three IP addresses of alternate C-LANs and/or
LSPs.
Note:
For an S8500 or S8700/S8710/S8720 primary controller, If you enter a
Note:
combination of both C-LANs and LSPs, you must list C-LANs first.
2. Type reset mgp at the MG-???-n(configure)# prompt to reset the G700 media gateway
processor.
A system prompt asks you to confirm the reset.
3. Select Yes at the dialog box that asks if you want to continue.
The G700 media gateway processor resets. The LEDs on the G700 media gateway and the
media modules flash. These elements each conduct a series of self-tests. When the LEDs
on the media modules are extinguished and the active status LEDs on the G700 media
gateway are on, the reset is complete.
The system ultimately returns you to the P330-1 (configure) prompt.
At the P330-1(configure)# prompt, type session mgp.
At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
Note:
Because the G700 media gateway has registered with its primary controller, the
Note:
prompt name has changed; for example, to MG-001-1.
Type show mgc to display the list of available servers and their IP addresses.
Configure the G700 Media Gateway
Issue 10.2 May 2007 453