Identifying The Survivable Processor On The Primary Controller - Avaya G700 Installing And Upgrading

Hide thumbs Also See for G700:

Table of Contents

Installing a new G700 with an S8300 using the Avaya Installation Wizard

Table 9: IP interfaces field descriptions (continued)

Target socket

3. Close the screen.

Identifying the Survivable Processor on the primary controller

If the primary server has LSPs, you must enter the LSP node names on the LSP form to enable

the LSPs to get translations updates from the primary controller. Once the LSPs are

successfully entered on the LSP form, their status can be viewed with the list

survivable-processor command.

The LSP node names must be administered on the node-names-ip form before

they can be entered on the LSP form.

1. At the SAT command line, type add survivable-processor <name>, where <name>

is the LSP name from the Node Names screen.

The Survivable Processor screen appears.

188 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server

Conditions/Comments

The threshold for the number of sockets used by this

C-LAN within the same Gatekeeper Priority as that of

other IP interfaces. If the targeted number is exceeded

on a CLAN, a warning alarm is generated. If the targeted

percentage is exceeded on an PE interface, a procr error

is generated.

Enter a 'y' to allow H.323 endpoint connectivity on this

CLAN. Enter 'n' if you do not want H.323 endpoints to

connect to this CLAN.

Enter 'y' to allow H.248 gateway connectivity to this

CLAN. Enter 'n' if you do not want H.248 gateways to

connect to this CLAN.

This value is used on the alternate gatekeeper list. The

lower the number the higher the priority. Valid values for

this field are one through nine with five being the default.

This field displays only if the allow H.323 endpoints field

is set to a yes on this form.