Inserting The Tgm550, The Tims, And The Pims In The Router, If Necessary - Avaya IG550 Installing And Configuring

Installing an IG550 Integrated Gateway using the Disk on Key
Inserting the TGM550, the TIMs, and the PIMs in the router, if
necessary
!
CAUTION:
Neither the TIMs nor the TGM550 should be inserted into the J-series router
CAUTION:
before you are sure the router is running release 8.2 or higher. Failure to comply
with this caution may cause your system to become inoperable.
The TGM550, the TIMs, and the PIMs should already reside in the router chassis. However, if
these items are shipped separately from the router, insert them into the router now with the
following steps.
1. Determine the slots in which to insert the TGM550 and TIMs. The slots must match the
configuration loaded on the Disk-on-Key. However, if not already configured, the TGM550
and TIMs can reside in any of the six slots. None of the slots is restricted from housing the
TGM550 or any particular model of TIM.
!
CAUTION:
If the Communication Manager media server is already administered for the slots,
CAUTION:
the slots in which you insert the equipment must also match exactly how the slots
are administered on the Media Gateway screen in Communication Manager.
!
CAUTION:
The router must be turned off before inserting or removing the Avaya TGM550
CAUTION:
and TIM modules. These modules are not hot-swappable. If you attempt to
remove or insert these modules while the router is turned on, the router might
reset or malfunction in some other way.
2. Ensure power is turned off.
3. Attach the blue filter inlet cover (see
and TGM550, front view (J4350 shown)
4. Insert the TGM550 and each TIM into the correct slot.
5. Align the notches in the connector at the rear of the TGM550, TIM, or PIM with the notches
in the slot in the router. Then slide the module in until it lodges firmly in the router.
!
CAUTION:
Carefully slide the module straight into the slot to avoid damaging the connector
CAUTION:
components.
6. Drive the screws to hold the module in place.
18 Installing and Configuring the IG550 Integrated Gateway
Figure 9: Sample illustration of Juniper Service Router
on page 25).