Accessing The Cli Via A Modem Connection To The S8300; Accessing Avaya Iw - Avaya G250 Administration Manual

Accessing the Avaya G250/G350 Media Gateway

Accessing the CLI via a modem connection to the S8300

If the Avaya G250/G350 Media Gateway includes an S8300 Server, you can access the CLI
from a remote location. This is done by establishing a PPP network connection from a modem
at the remote location to a USB modem connected to one of the USB ports on the front panel of
the S8300. The G250/G350 supports the Multitech MultiModem USB, MT5634ZBA-USB-V92.
Note:
In order to access the CLI via the S8300, the PMI of the G250/G350 must be
Note:
configured. See
page 90.
1. Connect a USB modem to either of the two USB ports on the Avaya S8300 Server.
2. Use the Avaya Maintenance Web Interface (MWI) to configure the USB port on the S8300
for modem use. For instructions, see Installing and Upgrading the Avaya G250 Media
Gateway, 03-300434 or Installing and Upgrading the Avaya G350 Media Gateway,
03-300394.
3. From a remote computer, create a dialup network connection to the S8300. Use the
TCP/IP and PPP protocols to create the connection.
4. Open any standard telnet program on the remote computer.
5. Enter the command telnet, followed by the IP address of the S8300 USB port to which
the modem is connected.
6. Enter the command telnet, followed by the PMI of the G250/G350.

Accessing Avaya IW

The Avaya Installation Wizard (Avaya IW) is a web-based installation wizard that is used with
the Avaya G250/G350 Media Gateway to perform initial configuration tasks and to upgrade
software and firmware. The Avaya IW is designed for use with systems that include an S8300
Server, operating in either ICC or LSP mode. See
(MGC) on page 92.
Specifically, you can perform the following tasks with the Avaya IW:
Configure PMI and SNMP information, Ethernet interfaces, primary and secondary Media
●
Gateway Controllers, G250/G350 telephony and trunk parameters, and alarms
Install license and password files, software, and firmware upgrades
●
Enable and configure the USB ports of the S8300 and G250/G350 for modem use
●
Change your password
●
44 Administration for the Avaya G250 and Avaya G350 Media Gateways
Configuring the Primary Management Interface (PMI)
Configuring the Media Gateway Controller
on