Top-Side Components
NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
NOTE: The engine does not need to be removed for
this procedure.
Removing Top-Side
Components
1. Remove the thermostat housing.
WT168
2. Remove the four cap screws securing the cylinder
head cover. Account for rubber washers and sili-
cone-held gaskets.
ROV1-005A
ROV1-001A
3. Remove the two fasteners securing the starter motor.
ROV1-116A
4. Remove the magneto and timing inspection plugs;
then turn the crankshaft to the TDC position.
ROV1-012
ROV1-013
5. Remove the cam chain tensioner. Account for a gas-
ket and the fasteners.
47