Default Configuration; Configuring Network Settings - Quantum Scalar i40 User Manual

Chapter 4: Configuring the Library

Default Configuration

Default Configuration

Configuring Network Settings

42
The library comes with a default configuration, which you can modify at
any time. The default configuration is as follows:
Feature
Library host name
Network settings
Number of partitions
Number of I/E station slots
Number of cleaning slots
The operator panel Setup Wizard allows you to configure network
settings that allow remote access to the library from the Web client. At a
minimum, you must initially configure the network IP address from the
operator panel. After the initial configuration, you can modify the
network settings from either the operator panel or the Web client.
Note: Changing the network settings may interrupt the library
connection and library communication. Your current browser
session may become invalid. If this happens, you must close
your browser and then restart it to reconnect to the library with
your new configuration settings.
Default Configuration
library
IPv4, DHCP enabled
IPv6 disabled
Equal to the number of installed tape
drive types (Fibre Channel or SAS).
Storage slots are divided equally
among the partitions.
5
0
Quantum Scalar i40 and Scalar i80 User's Guide