Configuring The Media Integrity Analysis Report - Quantum Scalar i40 User Manual

Chapter 6: Getting Information About the Library
Using Advanced Reporting
Configuring the Media
Integrity Analysis
Report
156
• Selected Partition — The report chart is based on an
individual partition in the physical library.
Note: See Installed Tape Drive Location Coordinates
page 8 for an explanation of the location coordinates.
3 Click
.
Next
The report is generated and appears on the screen.
1 From the library menu bar, select
Media Integrity Analysis
The Media Integrity Analysis Report configuration page opens. This
may take several minutes.
2 Configure the report by specifying the following:
• Date Range — Specifies the range of time covered by the report.
Choose Last 7 days; Last 4 weeks (default); Last 3 months; or All
History (as far back as there is data in the log file).
• Attributes— Specifies which values are included in the report,
and how they are combined. Select in any combination,
including all (default) and none. If you select no attributes, the
chart displays the Tape Alert count for the selected Grouping.
• Cartridge Barcode — All relevant tape cartridges.
• Drive Physical SN — All relevant tape drives.
• Tape Alert — The Tape Alert flags that were issued. For a
description of all Tape Alert flags, see
Flag Descriptions.
• Chart — How the data is displayed in the chart. Choose Area,
Bar (default), Line, or Pie.
• Type — The chart type. Select one of the following:
• Rollup (default) — Displays the number of Tape Alerts for
the combination of Grouping and Attributes you selected.
• Trend — Shows the occurrence of Tape Alerts over time.
• Grouping— Specifies which drive(s) or tape cartridge(s) on
which to base the report. Choose one of the following:
Reports > Advanced Reporting >
.
Quantum Scalar i40 and Scalar i80 User's Guide
on
Appendix B, TapeAlert