Chrysler 2005 Crossfire SRT6 Service Manual page 224

5 - 58 BRAKES - BASE
4. Align the brake booster (1) push rod to the holes
on the brake pedal (3) then install the brake rod pin
(2) and retaining clip (4) to the brake pedal (3).
5. Check the condition of the grommet that secures
the check valve (1) in the booster. Replace the
grommet if it is worn or damaged. Install the
booster check valve (1).
6. Connect the travel sensor harness connector (3)
and the solenoid valve harness connector (2).
WARNING: THE MASTER CYLINDER INSTALLA-
TION PROCEDURE MUST BE PERFORMED AS
WRITTEN OR DAMAGE TO THE BOOSTER/MAS-
TER CYLINDER MAY OCCUR.
7. Install the master cylinder with a new gasket and
retaining nuts. (Refer to 5 - BRAKES/HYDRAULIC/
MECHANICAL/MASTER CYLINDER - INSTALLA-
TION).
8. Connect the negative battery cable.
9. Fill and bleed the brake system.
• Manual bleeding: (Refer to 5 - BRAKES - STAN-
DARD PROCEDURE).
• Pressure bleeding: (Refer to 5 - BRAKES - STANDARD PROCEDURE).
ZH