Ignition Coil And Flywheel - Club Car 2005 FE290 Maintenance Service Supplement

FE290 ENGINE
3
8
1
6
Figure 13-6 Crankcase Cover Installation

IGNITION COIL AND FLYWHEEL

See General Warning, Section 10, Page 10-1.
Ignition Coil and Flywheel Removal
1. Loosen three screws and remove the remaining four screws attaching the flywheel housing as shown,
then remove the housing (Figure 13-7, Page 13-7).
2. Disconnect the ignition coil (1) from its primary lead wire at the connector (2). Remove the two bolts (3)
and take out the ignition coil (Figure 13-8, Page 13-7).
Remove.
Figure 13-7 Flywheel Housing
2005 FE290 Gasoline Vehicle Maintenance and Service Supplement
5
7
2
4
Loosen.
Remove.
Ignition Coil and Flywheel
2
1
Figure 13-8 Ignition Coil
13
A
3
Page 13-7