Check Points Of Every 150 Hours - Kubota SM-E4B Series Workshop Manual

SM-E4B SERIES, WSM

[6] CHECK POINTS OF EVERY 150 HOURS

Cleaning Fuel Filter (Element Type only)
1. Close the fuel cock (3).
2. Unscrew the retaining ring (6) and remove the filter cup (5), and
rinse the inside with kerosene.
3. Take out the element (4) and dip it in the kerosene to rinse.
4. After cleaning, reassemble the fuel filter, keeping out dust and
dirt.
5. Bleed the fuel system.
IMPORTANT
• If dust and dirt enter the fuel, the fuel injection pump and
injection nozzle will wear quickly. To prevent this, be sure
to clean the fuel filter cup (5) periodically.
(1) Cock Body
(2) Air Vent Plug
(3) Fuel Cock
Checking Battery Electrolyte Level
1. Check the battery electrolyte level.
2. If the level is below than lower level line (2), and the distilled
water to pour level of each cell.
(1) Upper Level Line
Replacing Oil Filter Cartridge (for Optional Depth Oil Pans)
CAUTION
• Be sure to stop the engine before changing filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
IMPORTANT
• To prevent serious damage to the engine, replacement
element must be highly efficient. Use only a KUBOTA
genuine filter or its equivalent.
(1) Engine Oil Filter Cartridge
G-15
GENERAL
(4) Filter Element
(5) Filter Cup
(6) Retaining Ring
9Y1210785GEG0016US0
(2) Lower Level Line
9Y1210785GEG0017US0
[a] Standard Type
[b] One-side Maintenance Type
9Y1210785GEG0018US0
KiSC issued 01, 2013 A