P0405 Egr Low Voltage - Isuzu 2000 Trooper Workshop Manual

Diagnostic Trouble Code (DTC) P0405 EGR Low Voltage
Circuit Description
The powertrain control module (PCM) monitors the EGR
valve pintle position input to ensure that the valve
responds properly to command from the PCM. If current
pintle position voltage indicates less than 0.1 V and last
more than 10 seconds, then the PCM will set DTC P0405.
Conditions for Setting the DTC
D Ignition voltage is between 11 and 16 volts.
D EGR pintle position is less than 2% and last more than
10 sec. Action taken when the DTC sets.
Action Taken When the DTC Sets
D The PCM will illuminate the malfunction indicator lamp
(MIL) as soon as failure detected.
D The PCM will store conditions which were present
when the DTC was set as Freeze Frame and in Failure
Records data.
TROOPER 6VE1 3.5L ENGINE DRIVEABILITY AND EMISSIONS
Conditions for Clearing the MIL/DTC
D The PCM will turn the MIL "OFF" on the third
consecutive trip cycle during which the diagnostic has
been run and the fault condition is no longer present.
D A history DTC P0402 will clear after 40 consecutive
warm-up cycles have occurred without a fault.
D DTC P0405 can be cleared by using the Tech 2 "Clear
Info" function or by disconnecting the PCM battery
feed.
Diagnostic Aids
Check for the following conditions:
D Poor connection or damaged harness – Inspect the
wiring harness for damage. If the harness appears to
be OK, observe the EGR actual position display on the
Tech 2 while moving connectors and wiring harnesses
related to EGR valve. A change in the display will
indicate the location of the fault.
6E–317
D06RY00178