Table of Contents
Advertisement
Refreshing the Design
Tool-tip Label
© National Instruments Corporation
After adding and changing elements, the design can begin to look a little
confusing, with bits and pieces of elements looking like they have been left
behind on the design after being moved, for example. This can be for many
reasons, including the limitations of the computer monitor being used,
although it does not affect the design.
Complete the following to clean up the design, removing any extraneous
images that should not be there:
1.
Choose View»Redraw Screen.
Or
Click Redraw in the View toolbar or press <F5>.
Complete the following to change your cursor to include a tool-tip label
that contains object information:
1.
Hold down the Ctrl key as you move your mouse over the workspace.
The information in the label changes depending on the object over
which it hovers.
2-11
Chapter 2
Beginning a Design
NI Ultiboard User Manual
Advertisement
Table of Contents
