Table of Contents
Advertisement
Appendix A
Menus and Commands
Place»Automatic Test Points
Place»Unplace Parts
Place»Comment
Design Menu
Design»Netlist & DRC Check
Design»Connectivity Check
NI Ultiboard User Manual
Use to automatically place a test point on each net on your design. Refer to
the
Placing Automatic Test Points
Autoplacement, for more information.
Use to unplace all non-locked parts. Refer to the
of Chapter 4,
Working with
Places a comment on the design. Refer to the
of Chapter 8,
Preparing for
information.
The subjects in this section describe the commands found in the Design
menu.
Use to run the design rules and netlist check utility. Results are displayed
in the DRC tab of the Spreadsheet View. Refer to the
DRC Tab
section of Chapter 1,
Depending on your settings in the PCB Design tab of the Preferences
dialog box, this utility may run automatically. You can use this command
to force a check of the board's integrity, and may want to use it prior to
saving or exporting the design.
Runs a connectivity check on the design.
When this command is selected, the Select a Net dialog box displays.
Select the net on which you wish to run the connectivity check and click
OK.
Results are displayed in the Results tab of the Spreadsheet View. Refer to
the
Spreadsheet View: Results Tab
more information.
section of Chapter 7,
Parts, for more information.
Manufacturing/Assembly, for more
User
Interface, for more information.
section of Chapter 1,
A-14
Autorouting and
Unplacing Parts
section
Placing a Comment
section
Spreadsheet View:
User
Interface, for
ni.com
Advertisement
Table of Contents
