Table of Contents
Advertisement
Chapter 1
User Interface
Spreadsheet View: Part Groups Tab
NI Ultiboard User Manual
Column
Pin Swap
If enabled, allows like-pins to be swapped during the
routing process. You can choose either No (not
enabled), Yes or Use Group Settings. Refer to the
Working with the Group Editor
Setting Up a
Gate Swap
If enabled, allows like-gates, to be swapped during the
routing process. You can choose Internal Gates
Only, which will swap gates within the same IC; No
Swapping; Advanced Swapping, which will swap
gates between ICs (both devices must be set to
Advanced Swapping); or Use Group Settings. Refer
to the
Chapter 3,
Part Group
The group in which the part is placed. You can select
No Group or an existing group from the drop-down
list. Parts groups are created in the Group Editor.
Refer to the
Chapter 3,
Use the Part Groups tab to work with part groups as described in the table
below.
Column
Part Group
This is the group in which the part is contained. Refer
to the
Chapter 3,
Trace
This is the minimum spacing allowed between the
Clearance
parts in the group and any trace. You can enter a value
here, or use the Group Editor. Refer to the
with the Group Editor
Design, section for more information.
Part Spacing
This is the minimum spacing allowed between parts in
the group. You can enter a value here, or use the
Group Editor. Refer to the
Editor
more information.
Description
Design, for more information.
Working with the Group Editor
Setting Up a
Design, for more information.
Working with the Group Editor
Setting Up a
Design, for more information.
Description
Working with the Group Editor
Setting Up a
Design, for more information.
of Chapter 3,
of Chapter 3,
Setting Up a
1-34
section of Chapter 3,
section of
section of
section of
Working
Setting Up a
Working with the Group
Design, section for
ni.com
Advertisement
Table of Contents
