National Instruments Graphical User Interface Ultiboard User Manual page 52

Chapter 1 User Interface
NI Ultiboard User Manual
Column
Min Width The minimum width to which a trace will be laid
during routing. You can enter a value here, or use the
Group Editor. Refer to the
Editor
more information.
Topology The topology of the net as set in the Netlist Editor.
Choices are Shortest, Daisy Chain and Star. Refer to
the
Working with Traces and
information. This feature is not available in all
versions of Ultiboard.
Trace Length Length of the routed net.
Max Length Maximum allowable length of copper in a net. Not
applicable (N/A) if Topology is set to Shortest.
Min Length MInimum allowable length of copper in a net. Not
applicable (N/A) if Topology is set to Shortest.
Trace This is the minimum spacing allowed between the
Clearance parts in the group and any trace. You can enter a value
here, or use the Group Editor. Refer to the
with the Group Editor
Up a
Routing The routing layers assigned to this net group. Click to
Layers display the Layers to Apply dialog box, where you
set the layers to use for routing copper.
Routing The routing priority for the selected net. 1 is the
Priority highest priority, 2 the second highest, etc. Leave as
None if priority routing is not required. This feature is
not available in all versions of Ultiboard.
Net Group This is the group in which the net is contained. You
can either enter the group name here, or use the
Group Editor. Refer to the
Editor
more information.
1-36
Description
of Chapter 3, Setting Up a
Using the Netlist Editor
section of Chapter 3,
Design, for more information.
section of Chapter 3,
Working with the Group
Design, section for
section of Chapter 5,
Copper, for more
Working
Setting
Working with the Group
Setting Up a Design, for
ni.com