National Instruments Graphical User Interface Ultiboard User Manual page 133

© National Instruments Corporation
If you chose SMT in step 1 of the wizard, the Package Type choices
shown below appear:
• SOT (Small Outline Transistor)
• TO (Transistor Outline)
• SO-Gullwing (Small Outline, SOIC, SOP, TSSOP)
• SO-J (Small Outline J Lead)
• PLCC (Plastic Leaded Chip Carrier Package)
• QFP (Quad Flat Package)
• BGA (Ball Grid Array Package)
• SBGA (Staggered Ball Grid Array Package)
• SIP (Single in Line Package)
• ZIP (Zigzag in Line Package)
4. Choose the desired Package Type and click Next to display step 3 of
the wizard.
The following Package Dimension choices appear:
• Units—Select the unit of measure from the drop-down list.
• X—The "x" dimension of the part (displayed on the preview).
• Y—The "y" dimension of the part (displayed on the preview).
• 3D Height—The height of the the part, as displayed in the 3D
view.
• 3D Offset—The distance between the PCB and the bottom of the
part.
• Corner Cutoff - Notch (A)—The size of the notch on the part.
• Corner Cutoff - Left Top—Places the notch on the left top of the
part.
• Corner Cutoff - Right Top—Places the notch on the right top of
the part.
• Corner Cutoff - Left Bottom—Places the notch on the left
bottom of the part.
• Corner Cutoff - Right Bottom—Places the notch on the right
bottom of the part.
• Circle Pin 1 Indicator—Enable to show a circle around pin 1 of
the part.
4-37
Chapter 4 Working with Parts
NI Ultiboard User Manual