Table of Contents
Advertisement
Chapter 3
Setting Up a Design
Note
You cannot assign a net to more than one differential pair. Therefore, nets that are
already assigned to another differential pair do not appear in the Assign Nets list.
Refer to the Change Group Settings dialog box and
Note
sections for more information.
Change Group Settings dialog box
NI Ultiboard User Manual
8.
Click two checkboxes beside the desired nets in the Assign Nets list
and click Apply to add them to the group.
9.
Click OK to close the Edit Groups dialog box.
Complete the following steps to edit a bus group:
1.
Select Tools»Group Editor to display the Edit Groups dialog box.
2.
Select the Differential Pairs tab.
3.
Highlight the desired group in the Groups list.
4.
Change the net assignments as desired and click Apply.
5.
Optionally, highlight the desired group in the Groups list and click the
Properties button to display the Change group settings dialog box.
6.
Make the required changes in the Group Settings area and click OK.
Complete the following steps to delete a group:
1.
Select Tools»Group Editor to display the Edit Groups dialog box.
2.
Select the Differential Pairs tab.
3.
Highlight the desired group in the Groups list and click Delete.
Access this dialog box from the Edit Groups dialog box. Refer to the
Working with the Group Editor
Use this dialog box to change the group settings for net groups, part groups,
and differential pairs.
The options found in this dialog box depend on the type of group. Refer to
the following sections for more information:
•
Net Group Settings
•
Part Group Settings
•
Differential Pair Settings
section for more information.
3-18
Differential Pair Settings
ni.com
Advertisement
Table of Contents
