Design»Fanout Smd; Design»Add Teardrops; Design»Corner Mitering; Design»Remove Unused Vias - National Instruments Graphical User Interface Ultiboard User Manual

Appendix A Menus and Commands
Design»Fanout SMD
Design»Add Teardrops
Design»Corner Mitering
Design»Remove Unused Vias
Design»Group Replica Place
Design»Copy Route
Design»Highlight Selected Net
NI Ultiboard User Manual
Use to place a via fanout for a SMD part. Refer to the
section of Chapter 5,
information.
Use to add teardrops to pads. Refer to the
section of Chapter 5,
information.
Use to apply corner mitering before production. Refer to the
Corners section of Chapter 8,
more information.
Use to delete all vias that do not have any trace segments or copper areas
connected to them. Use this command after Edit»Copper Delete»Open
Trace Ends to clean up the design. Refer to the
section of Chapter 8,
information.
Use to copy and place a group of parts. Refer to the
section of Chapter 4,
Use to copy copper routing between groups. Refer to the
Route section of Chapter 5,
information.
Use to select and highlight an entire net when you have selected one trace
segment of that net. Refer to the
Working with Traces and
Working with Traces and
Adding and Removing Teardrops
Working with Traces and
Preparing for
Preparing for Manufacturing/Assembly, for more
Working with Parts, for more information.
Working with Traces and
Highlighting a Net
Copper, for more information.
A-16
Placing SMD Fanouts
Copper, for more
Copper, for more
Mitering
Manufacturing/Assembly, for
Deleting Unused Vias
Replicating a Group
Copying a Copper
Copper, for more
section of Chapter 5,
ni.com