Table of Contents
Advertisement
Chapter 1
User Interface
NI Ultiboard User Manual
3.
Set the viewing options in the View area:
•
Show pin 1 mark—Enable to display pin 1 of a device with a
unique marking.
•
Show Copper Areas—Enable to display copper areas. This
applies to copper areas only, not regular polygon shapes on
non-copper layers.
•
Show pin info in pin—Enable to display the pin number and hole
size when zoomed in.
4.
In the On select entire trace area:
•
Select Across Layers—Enable so that when you choose
Edit»Select Entire Trace, the trace will be selected across all
layers, instead of just the active layer.
5.
In the Part Drag area:
•
Re-route after move—Enable if you would like the traces that
are attached to a part to be re-routed if you move the part.
6.
In the Default pin diameters area:
•
Units—Select unit of measurement from drop-down list.
•
Jumpers—Enter the default pin diameter for jumpers.
•
Testpoints—Enter the default pin diameter for testpoints.
7.
In the Action on DRC error area, set the actions to be taken when
Ultiboard encounters a Design Rule Error:
•
Cancel the current action—Enable to prevent the current
operation from being completed. For example, placing a trace
over a pad that is part of a different netlist will not be permitted.
•
Ask for Confirmation—Enable so that if an invalid operation is
attempted a prompt is given asking if the operation should be
completed even though a Design Rule will be violated.
•
Overrule—Enable to permit the operation to be completed.
8.
In the On trace deletion area:
•
Auto delete Via (standard)—Enable to have vias automatically
deleted when you delete the trace associated with that via.
•
Auto delete teardrop—Enable to have teardrops automatically
deleted when you delete the trace associated with that teardrop.
1-16
ni.com
Advertisement
Table of Contents
